Air Spring Helper Kit from Mill Supply

Free quart of hydraulic fluid with on-line order over $50.00

Coil Rite

Ride-Rite

Coil-Rite

The coil spring is ideally suited for the Coil-Rite helper kit which provides lift assistance to a coil sprung suspension, with a carrying capacity of up to *1000lbs. per set. Front Suspension

Ride-Rite

The leaf springs are edeally suied for the Ride-Rite helper kit which provide assistance to a leaf spring suspension, capable of *5000 lbs. lift capacity at 100 p.s.i., enhancing the ride of your vehicle.

Air Command

Air Helper Spring Command

2158 Level Command II Standard Duty Compressor Single Gauge Inflates Air Springs Equally.

Dual Air Helper Spring Command

2168 Dual Air Command Heavy Duty Compressor Dual Gauge Inflates Air Springs Individually.

Pro-Wing Plow Attachment

Pro-Wing Plow Attachment

Pro-Wing provides an additional 20" of blade width with a minimal increase in plow weight. Trailoff is reduced and problem areas such as parked cars or moving snow across a lot becomes manageable. Plowing time can be reduced from 25-50%. Pro-Wings fit 98% of pickup mounted snow plows. Pro-Wings are not recommended for Meyer® 2 meter, Western® 8 1/2', or any brand 9' or 10' plows, except for Meyer® 9'. Installation is a short two hours without special tools, and then just 3 quick pins per side to remove or replace each wing in seconds. The tripping action of your plow is unaffected by Pro-Wings. The rubber edge on the wings is long lasting and helps prevent damage to the wings. U.S. PATENT #4-962-600 PW-22 - Pro Wing Plow Attachment Price (see online catalogue) RE-20500 - Rubber Edge Only Price ea.

Non-Stick Snow Plow Liner

Non-Stick Snow Plow Liner

153-9628 - Yellow 153-9630 - Red • Non Stick Surface • No More Repainting Moldboard • (9) Stainless Steel Carriage bolts with nuts included • Available in Red or Yellow • One size only: 96" x 28" Trim with aviation snips or sharp knife to fit your plow.

Snow Plow Dolly

Snow Plow Dolly

• 3 heavy-duty powder coated steel bases rated at 1000 lbs each.

• No special tools needed. Just hook the plow, raise it up and go.

• Allows you to easily store your snow plow in areas you normally wouldn’t.

• Adjust and keep the plow at the proper height with the Plow Level-RTM attachment.

• Eliminates aches, pains, and frustrations when trying to hook up your plow in freezing weather.

Poly Snow Deflector

Poly Snow Deflector

This deflector, rigid yet flexible comes in a standard 8' length and can be easily cut down to any desired length. Constructed of polyethylene, will not crack in cold weather.

• Roll snow better than standard deflectors

• Snow won't stick up in it

• Won't shatter or break even in below freezing weather.

Meyer® snowplow
parts

Snowplow pump rebuilding service